Roland Advanced Jet AJ-1000 Service Notes page 119

Hook the Flexible Cable to the Flame as shown in the
15
figure.
16
Disconnect the all Tubes which are to be iserted into the
Cable Veyor from the Pressure Pumps and pull out the
tubes from the Cable Veyor.
Insert new Ink Tubes.
17
Insert the opening end of tube into the Cable Veyor
whichi is to be connected to the Damper later.
Make sure that the shortest tube located in front.
Connect the Ink Tubes to the Pressure Pumps.
18
1) Make sure the O Ring is set in the Tube
Joint firmly.
<Upper view>
Carriage Board
Pressure Pump
Cable Veyor
O Ring
Tube Joint
3-34
<Rear view>
Flame
Flexible Cable
Pressure Pump
Tube Joint
Ink Tube
Shortest Tube
<Front view>