Roland Advanced Jet AJ-1000 Service Notes page 89

Hide thumbs Also See for Advanced Jet AJ-1000:
Table of Contents

Advertisement

When the Head Carriage moves up and the LCD shows
4
[REPLACE HEAD PREPARE], turn off the Sub Power
SW and then, turn off the Printer Main Power SW.
When replacing the Head, it is necessary to
turn off the Printer Main Power SW. If not, the
Head or the Main Board could be broken. We
recommend replacing the Head with plugging
off the AC Cord.
Remove the Carriage Cover.
5
from dropping in the maintenance liquid tray
HEAD CARRIAGE slowly leftwards to the position where
the Capping Unit is not below the Head Carriage.
Disconnect the flexible cable from the Head to be replaced.
6
The Heater cable is connected to the Black
Head, however do not disconnect it at this
moment.
Put the tape as shown in the figure.
7
Disconnect the Ink Tube from Ink Dampers and clean up
inks around the Ink Tube.
Then, put the Ink Tube
Then, to prevent the screw
move the
on the tape.
<Rear View>
Dryer Main Power SW
Capping Unit
Flexible Cable
Heater Cable
Tube
3-4
Printer Main Power SW
Carriage Cover
Tape

Advertisement

Table of Contents
loading

Table of Contents