Note:
The default transition point value is 1. The default primary search time is
Note:
1 minute. The total search time is 30 minutes.
Configuring the WAN interface
See the Juniper J-series Services Router Basic LAN and WAN Access Configuration Guide for
procedures on how to configure an E1, T1, E3, or T3 WAN interface.
Cabling an Ethernet port on the J-series router
1. Plug an RJ-45 Ethernet cable into one of the Gigabit Ethernet ports that you administered
on the router
2. Attach the other end of the cable to the LAN.
Logging in to the TGM550
1. At the cli prompt (>), type ssh <login>@<ip_address>, where <login> is root or
another valid login, if previously administered, and <ip_address> is the IP address of the
TGM550, and press Enter.
The message, Are you sure you want to continue connecting? appears.
2. Enter yes.
3. At the password or challenge prompt, type the password and press Enter.
You are now logged-in.
- If you are prompted to change the root password, change the password to a password
agreed upon with the customer administrator.
(Figure
12,
Figure
13, or
Figure
14).
Issue 2 January 2008
107