Checking The Authentication File Id (Avaya Personnel Only) - Avaya IG550 Installing And Configuring

6. At the TGM550 command line, type set boot bank bank-<bank>
where <bank> is the same letter that you entered in step 2.
For example, type:
set boot bank bank-A
7. Type copy running-config start-config.
!
CAUTION:
Before you continue with Step 8, ensure you ran the copy running-config
CAUTION:
start-config command on the TGM550. The command in Step
loss of any administration on the TGM550 since the last copy
running-config start-config command was run.
8. Type exit to return to the CLI of the router.
The Juniper CLI prompt appears.
9. At the CLI prompt (>), type request chassis fpc restart slot <slot_number>
where <slot_number> is the slot number of the TGM550.
The TGM550 media gateway processor resets.
10. Log in to the TGM550 again.
The software banner that scrolls on the screen shows the new firmware version.
11. If you did no see the firmware version on the software banner, then, at the
TGM550-00<super># prompt, type show mg list_config.
The system displays the list of firmware.

Checking the authentication file ID (Avaya personnel only)

9 will cause a
Issue 2 January 2008 79