Table of Contents
Advertisement
Configuring the G150 Media Gateway with Manager
Configuring the WAN Expansion Card for Connection to the
Communication Manager
The WAN expansion card is fitted to the back of the G150 to provide a single WAN connection
(X.21, V.35 or V.24 via a 37-way D-type socket). Line speeds up to and including 2Mbps are
supported on the interface. The carrier providing the line dicates the actual operating speed. In
some territories, the maximum speed may be 1.544M.
If used, the WAN expansion card can be configured for connection to the Communication
Manager by configuring the following on Manager:
Create a WAN service
Edit the WAN Port
Create an IP Route
To create a WAN service:
1. Click
displaying the IP address of the G150. Enter the G150 system password.
2. Click Services from the Configuration Tree.
3. Right-click in the right-hand side of the Manager configuration window and select New. A
service configuration window displays.
4. Select the WAN Service type.
5. Click OK.
6. Select the Service tab.
7. In the Name field enter an appropriate name, such as "WAN Connection".
In the Incoming Password field and the associated Confirm Password field
immediately below, enter a password for this WAN service/account.
This account name and password will be used at the Communication Manager end to
establish a connection.
This will also automatically create a RAS entry with the same name.
8. In the Account Name and Password fields, enter the associated information as provided
by the WAN account created at the Communication Manager end.
9. Click OK.
Editting the WAN port
DO NOT create a new WAN Port, this is automatically detected by the G150. If a WAN Port is
not displayed, connect the WAN cable, reboot the G150 and receive the configuration. The
WAN Port configuration form should now be displayed.
138 Installation and Configuration of the G150 Media Gateway
to receive a configuration form. The Receiving Config from dialog box appears
Advertisement
Table of Contents
