Checking The Mgc List Transition Points; Pinging The Communication Manager Server - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway with the CLI
Tip:
After a specific user login and password have been administered on the
Tip:
TGM550, you can alternatively use the following command to log into the
TGM550 from the router interface:
request tgm login fpc <slot> user <tgm-user>
where slot is the slot number of the TGM550 and
user.

Checking the MGC list transition points

1. At the TGM550 command line, type show recovery and check the transition points for
the mgc list.

Pinging the Communication Manager server

1. At the TGM550 command line prompt, type ping <ip_address>, where <ip_address>
is the IP address of the server.
Replies from the server scroll down the screen.
2. If the TGM550 does not successfully ping the server, do the following:
a. At the command line prompt, type exit.
The ssh connection drops and reverts to the Unix command line of the router.
b. At the Unix command line, type cli, and press Enter.
c. Type ping <ip_address>, where <ip_address> is the ip address of the server.
Replies from the server scroll down the screen.
3. If the router does not successfully ping the server, review the configuration using the
following commands:
a. At the CLI command line, type show configuration | display set, and press
Enter.
108 Installing and Configuring the IG550 Integrated Gateway
,
is the login of the
tgm-user