Reconnecting Dc Power; Turning On The J-Series Router; Connecting Your Pc Or Laptop To The Console Port On The J-Series Router - Avaya IG550 Installing And Configuring

Reconnecting DC power

1. Use one of the removed screws to secure the positive (+) DC source power cable lug to the
RTN terminal.
2. Use the other removed screw to secure the negative (-) DC source power cable lug to the
-48 VDC terminal.
3. Dress the power cables appropriately.
4. Replace the clear plastic cover over the terminal block.
5. Verify that the power cables do not block access to router components or hang where
people might trip on the cables.
6. Restore power to the power leads.

Turning on the J-series router

1. Press the power button to turn on the router
The system starts. When the system is running normally, the Power on LED lights steady
green.
Connecting your PC or laptop to the console port on the J-series
router
1. Turn off the power to the personal computer or laptop that you use to access the command
line interface (CLI). Plug one end of an Ethernet rollover cable into the RJ-45-to-DB-9 serial
port adapter
Note:
Use the specific cable and adapter for the router. You cannot use the cable and
Note:
the adapter that comes with the TGM550.
(Figure 44).
(Figure 12).
Issue 2 January 2008 129