Configuring The Wan Ethernet Port; Configuring Additional Features On The Wan Ethernet Port - Avaya G250 Administration

Configuring Ethernet ports
Use the set port level command to determine the default packet priority level for
●
untagged packets. Packets traveling through a port set at normal priority should be served
only after packets traveling through a port set at high priority are served.
Use the set port name command to configure a name for a port.
●
Use the set port negotiation command to enable or disable the link negotiation
●
protocol on the specified port. This command applies to Fast Ethernet or Gigabit Ethernet
ports. When negotiation is enabled, the speed and duplex of the Fast Ethernet ports are
determined by auto-negotiation. If negotiation is disabled, the user can set the speed and
duplex of the Fast Ethernet ports.
Use the set port point-to-point admin status command, followed by the
●
module and port number of the port, to manage the connection type of the port. Use one of
the following arguments with this command:
- force-true — the port is treated as if it were connected point-to-point
- force-false — the port is treated as if it were connected to shared media
- auto — the G350 tries to automatically detect the connection type of the port
Note:
This command is not supported by the G250.
Note:
Use the set port speed command to configure the speed of a port or range of ports. In
●
auto-negotiation mode, the port's speed is determined by auto-negotiation. An error
message is generated if you attempt to set the speed when auto-negotiation is enabled.

Configuring the WAN Ethernet port

1. Use the interface FastEthernet 10/2 command to enter the context of the port
interface.
2. Perform basic configuration of the interface. For more information, see
interfaces
3. Use the Ethernet WAN port configuration commands in the context of the port interface.
See WAN Ethernet port commands

Configuring additional features on the WAN Ethernet port

Primary Management Interface (PMI). For more information, see
●
Management Interface (PMI)
Advanced router features. For more information, see
●
VoIP queuing. For more information, see
●
178 Administration for the Avaya G250 and Avaya G350 Media Gateways
on page 403.
on page 70.
on page 179.
Chapter 18: Configuring the
Configuring QoS parameters
Configuring
Configuring the Primary
router.
on page 206.