Updating Tgm550 Firmware, If Necessary - Avaya IG550 Installing And Configuring

b. At the Unix command line, type cli, and press Enter.
c. Type ping <ip_address>, where <ip_address> is the ip address of the server.
Replies from the server scroll down the screen.
3. If the router does not successfully ping the server, review the configuration using the
following commands:
a. At the CLI command line, type show configuration | display set, and press
Enter.
b. Review the configuration with the project manager or customer to ensure the IP
addresses are correct.

Updating TGM550 firmware, if necessary

Perform this task if the TGM550 firmware that resides on the TGM550 is not the most recent
firmware or is incompatible with the existing JUNOS software.
!
CAUTION:
Update firmware on the TGM550 before you update JUNOS software on the
CAUTION:
J-series router. The newer TGM550 firmware can normally operate with older
JUNOS software, but older TGM550 firmware may not be able to operate with
new JUNOS software.
1. At the TGM550-00<super># prompt, type show boot bank to determine the nonactive
disk partition or bank. You copy the firmware to this nonactive boot bank.
2. At the TGM550-00<super># prompt, type ping <IP_address>, where <IP_address>is
the address of the TFTP or FTP server.
3. Verify that there is a response from the server.
4. At the TGM550-00<super># prompt, type one of the following commands, depending on
whether the file resides on an FTP server or a TFTP server:
For a TFTP server, type copy tftp SW_image<bank> <filename>
●
<tftp_server_ip_address> to transfer the image from the tftp server to the
TGM550 boot bank,
Issue 2 January 2008 37