Configuring The Wan Ethernet Port; Configuring Additional Features On The Wan Ethernet Port - Avaya G450 Manual

Configuring Ethernet ports
Table 53: Switch Ethernet port configuration CLI commands (continued)
Command
set port enable | disable
set port flowcontrol
set port level
set port name
set port negotiation
set port point-to-point
admin status
set port speed
show port auto-negotiation-
flowcontrol-advertisement
show port edge state
show port flowcontrol

Configuring the WAN Ethernet port

1. Use the interface fastethernet
command to enter the context of the port interface.
2. Perform basic configuration of the interface. For more information, see
interfaces
3. Use the Ethernet WAN port configuration commands in the context of the port interface.
See WAN Ethernet port commands

Configuring additional features on the WAN Ethernet port

Primary Management Interface (PMI). For more information, see
●
Management Interface (PMI)
Advanced router features. For more information, see
●
196 Administration for the Avaya G450 Media Gateway
on page 443.
on page 80.
Description
Enable or disable a port or a range of ports
Set the send/receive mode for flow control frames
(IEEE 802.3x or proprietary) for a full-duplex port
Set the default packet priority level for untagged
packets
Configure a name for a port
Enable or disable auto-negotiation on the port
Set the connection type of the port: force-true,
force-false, or auto
Set the speed of a port or range of ports
Display the flow control advertisement for a Gigabit port
used to perform auto-negotiation
Display the edge state of a port
Display port flow control information
or interface fastethernet
10/2
on page 197.
Configuring the router
2 of 2
10/4
Configuring
Configuring the Primary
on page 443.