Inserting The Tgm550, The Tims, And The Pims In The Router, If Necessary - Avaya IG550 Installing And Configuring

Installing an IG550 Integrated Gateway with an existing Juniper J4350/J6350 Services Router
Inserting the TGM550, the TIMs, and the PIMs in the router, if
necessary
!
CAUTION:
If the J-series router was not shipped with the TGM550 and other boards already
CAUTION:
inserted, you should not insert the TGM550 and the other boards into the J-series
router before you are sure the router is running release 8.4 or higher. Failure to
comply with this caution may cause your system to become inoperable.
The TGM550, the TIMs, and the PIMs should already reside in the router chassis. However, if
these items are shipped separately from the router, insert them into the router now with the
following steps.
1. Determine the slots in which to insert the TGM550, TIMs, and PIMs. The slots must match
the configuration you plan to set up on the Communication Manager server. In addition, the
modules must be inserted according to limitations of the supported router models and slots.
Slot numbering on the routers is as follows:
J2320
●
J2350
●
J4350
●
122 Installing and Configuring the IG550 Integrated Gateway
Juniper R J2320
NETWORKS
RESET
CONFIG
0/0 0/1
POWER CONSOLE AUX TX/RX LINK TX/RX LINK TX/RX
10/100/1000
Juniper R J2350
NETWORKS
RESET
CONFIG
0/0 0/1
POWER CONSOLE AUX TX/RX LINK TX/RX
10/100/1000
1
SLOT NUMBER
1 2
3
USB0 USB1
0/2 0/3
LINK TX/RX LINK
1
2
SLOT NUMBER
1 3
2 4
USB0 USB1
0/2 0/3 5
LINK TX/RX LINK TX/RX LINK
2
3
hwma232s LAO 061407
3
4
5
hwma235s LAO 061407