Table of Contents
Advertisement
After Replacing the Image Transfer Roller
1. Make sure that the machine is off.
2. Open the left and right front door of the machine.
3. Switch the machine on.
4. Enter the SP mode.
5. Reset the PM part counter for the transfer roller to zero (SP 7622-
020).
6. Leave the SP mode.
7. Close the left door and right door of the machine.
8. Process control will start automatically.
9. A message on the operation panel will tell you that process
control has completed.
10. Enter the SP mode.
11. Do SP3012-001 to confirm that the process control execution
completed successfully.
12. Leave the SP mode.
This completes the procedure.
Slide 384
No additional notes
Replacement and Adjustment
384
BR-C1 Training
Advertisement
Table of Contents
