Ricoh BR-C1a Basic Service Training page 323

 LED On Timing: The LED of the tray selected for paper feed
switches on at the start of the job.
 LED Off Timing: The LED goes off after the trailing edge of
the last sheet leaves the fusing unit exit sensor. During
duplex printing, the LED does not go off until the last
duplex printed sheet has left the fusing exit sensor.
 Paper End During Operation
 Tandem Tray. The LED of the right paper tray goes off
when the right tray paper end sensor detects no paper. The
left tray LED remains on, and then the right tray LED goes
on again when paper has been moved from the left tray to
the right tray.
 Tray 2, Tray 3. The LED goes off at paper end.
 Paper Jam, Other Problem: The LED goes off when a paper
jam or other problem occurs (SC codes other than logged
SC codes).
 When a Tray Is Removed: LED on/off status continues even
if tray is removed.
Slide 323
 This is a new feature (not in Katana-C2).
Tray LED Operation
323
BR-C1 Training