Ricoh BR-C1a Basic Service Training page 176

 After Installation of a New HDD Unit
1. Do SP5-832-001 to format the hard disk.
2. Do SP5-853-001 to copy the preset stamp data from the
3. Do SP5-846-052 to copy back the address book to the
4. Turn the main power switch off/on.
 Make sure the cables are correctly connected on the
controller board: Red cable: Upper socket, Black cable:
Lower socket.
 If the connections are reversed, the machine will issue an
Slide 176
No additional notes
Replacement
HDD Unit - 2
firmware to the hard disk
hard disk from the SD card to which you have already
copied the address book data if possible.
error at startup. If it occurs, reconnect the HDD correctly
and start again. The HDD will not be damaged by such an
incorrect startup.
176
BR-C1 Training