Basic Editing ─ Selection Of A Network And Operation - Delta AS Series Operation Manual

A S S e r i e s O p e r a t i o n M a n u a l
 To insert a normally-closed contact (contact B), type "B <device address>"
 To insert an output coil (OUT), type "O <device address>"
Basic Editing ─ Selecting a Network and Operation
6.5.4
Before you select an object in a network, press Esc on the keyboard, or click
cursor appears as a small arrow, click the object in the network. The basic selection shows below.
_6

Select the network

Select the input contact

Select the network

Select the output coil

Select the block
To select a group of devices, click a device and drag it to draw a frame around the group of devices. You can
also select the group of devices by clicking the first device, pressing Ctrl+B on the keyboard, clicking the last
device, and then pressing Ctrl+B on the keyboard. You must draw a frame around devices that are in the same
network, and the devices must be adjacent to one another. Input and output devices cannot be in the same
frame.
6 - 1 4
on the toolbar. After the