Delta AS Series Operation Manual page 313

Item
Table name
Device quantity
Default update cycle
"Edit"
"Delete"
Device
Radix
Read only
Description
"Apply"

Operation Steps:
a. After log in, double-click Data monitor setup to open the setting page.
C h a p t e r 9 E t h e r n e t S p e c i f i c a t i o n a n d O p e r a t i o n
Description
To name your table, you can use up to 16 characters from the
following characters, A through Z (case-insensitive ), 0 through 9,
_ (underscore) , (comma) and . (dot) .
Device quantity to be monitored; default: read only
Set up the updated cycle time; default: 5 seconds; unit: second
Click "Edit" to edit the table and the table name column turns
green. The table contents appear below.
Click "Delete" to delete the table and its contents.
Devices to be monitored; you can enter the following devices to
monitor xX, yY, mM, sSmM, sSrR, dD, sS, tT, cC, hHcC and eE.
Positional numeral system to be shown on the monitoring page;
available formats are Signed decimal, Unsigned decimal,
Hexadecimal, Octal, Binary, 32bit Signed decimal, 32bit Unsigned
decimal, 32bit Hexadecimal, 32bit Octal, 32bit Binary, 32bit Float
and 64bit Double
Set up the monitored devices to read only or not.
Add a description here for the table.
Click "Apply" to save the settings.
9_
9 - 1 0 5