Notes
Enable BOOTP: when the IP address receiving mode is BOOTP (BOOTP is enabled), the IP address is
assigned, and the device sends out BOOTP requests for IP addresses during each power-on.
Enable DHCP: when the IP address receiving mode is DHCP (DHCP is enabled), the IP address is assigned,
and the device sends out DHCP requests for IP addresses during each power-on.
Disable DHCP/BOOTP: when BOOTP is disabled, the device does not send out any DHCP/BOOTP requests
for IP addresses during each power-on.
9.4.2.4 Re-enable BOOTP/DHCP
To enable the DHCP or BOOTP function again, use the device software to make the change. Using the AS Series as an
example: from the Start menu, start ISPSoft, then HWCONFIG, and then IP Manager. In IP Manager sets the IP address
to the receiving mode.
Steps to set device parameters
1.
Refer to Section 9.4.1.1 for how to start HWCONFIG.
2.
Set the parameters: enable the IP address receiving mode to BOOTP/DHCP.
C h a p t e r 9 E t h e r n e t S p e c i f i c a t i o n a n d O p e r a t i o n
Set up
Open
parameters
HWCONFIG
Open
Open
IP Manager
EI P Builder
Download
HWCONFIG
Set up I P
receiving mode
9_
9 - 2 1