I/O Module Connection Port; Basic Operation; Connecting Dvpdt02-H2 To Dvp-Eh2 Series Plc Mpu; Install Dvp-Eh2 And Dvpdt02-H2 On Din Rail - Delta DVPDT02-H2 Operation Manual

DeviceNet Slave Communication Module DVPDT02-H2
Please set up the switch when the power is switched off. After the setup is completed, re-power
DVPDT02-H2.
When DVPDT02-H2 is operating, changing the setting of the switch will be invalid.
Use slotted screwdriver to adjust the switch carefully in case you scratch the switch.
2.6

I/O Module Connection Port

The I/O module connection port on DVPDT02-H2 is used for the connection to the next DVPDT02-H2 or I/O
modules of DVP-EH2 series PLC MPU.
3

Basic Operation

3.1

Connecting DVPDT02-H2 to DVP-EH2 Series PLC MPU

Open the connection port on the right hand side of DVP-EH2 and connect DVPDT02-H2 to DVP-EH2.
3.2

Install DVP-EH2 and DVPDT02-H2 on DIN Rail

Use 35mm DIN rail.
Open the DIN rail clip on DVP-EH2 and DVPDT02-H2. Insert DVP-EH2 and DVPDT02-H2 onto the DIN
rail.
Clip up the DIN rail clips on DVP-EH2 and DVPDT02-H2 to fix DVP-EH2 and DVPDT02-H2 on the DIN
rail.
6
P O W E R
R U N
ST O P R UN E R R O R
B AT. LO W
0 1
IN
O U T
DVP-20 EH
R UN
ST OP
0 1
DVP-20EH
PO W ER
R U N
ER R OR
BAT. LOW
IN
OU T
DVP-PLC Operation Manual