6.3.1.2
Removing the dummy cover
Figure 66: Removing the dummy cover
Ê Press in on both release latches (1) and remove the PSU dummy cover (2).
V
CAUTION!
Keep the dummy cover for future use. If a PSU is removed and not
immediately replaced by a new one, a dummy cover must be installed in
the bay again to comply with applicable EMC regulations and satisfy
cooling requirements.
6.3.1.3
Installing a hot-plug PSU
Figure 67: Folding up the handle
Ê Push the handle of the PSU halfway upward in the direction of the arrow.
TX1330 M4
Upgrade and Maintenance Manual
Power supply unit (PSU)
137