4.4
Getting access to the component
V
CAUTION!
Before removing or installing covers, turn off the server and all
●
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the server cover is removed.
For more information, see chapter
●
page
37.
Only valid for the floorstand model: Do not lift the server by the
●
front cover in order not to damage the locking clips.
4.4.1
Rack model
4.4.1.1
Extending the server out of the rack
V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
●
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
●
or pushing it back. Failure to do so may cause injury.
For more safety information, see chapter
●
page
37.
Ê Remove all remaining external cables from the rear connector panel and
expansion cards.
TX1330 M4
Upgrade and Maintenance Manual
Basic hardware procedures
"Important information" on
"Important information" on
55