Removing A 2.5-Inch Hdd/Ssd Module - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) / solid state drives (SSD)
V
CAUTION!
All data on all HDDs/SSDs in the array will be lost when deleting the
array! Be sure to back up your data before deleting a RAID array.
For more information, refer to the "ServerView Suite RAID
Management" user guide.
Ê If applicable, "Getting access to the component" on page
7.4.7.2

Removing a 2.5-inch HDD/SSD module

Ê Pinch the green locking clips and open the locking lever (see
page 200).
Ê Pull the HDD/SSD module out a few centimeters.
Ê Wait about 30 seconds to allow the HDD to spin down.
I
This is not necessary when removing an SSD.
I
This period is necessary for the RAID controller to recognize that an
HDD module has been removed and for the HDD to come to a stop.
Ê Pull the HDD/SSD module completely out of its bay.
208 Upgrade and Maintenance Manual
55.
figure 118 on
TX1330 M4