Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 461

Pos. Label Indicator
AC
6 connected
indicator
iRMC-related status signals
ID indicator
blue flashing
blue flashing
I
For further information, see section
and the iRMC S5" on page
TX1330 M4
Status
green on
off
Global error
indicator
off
orange flashing
102.
Upgrade and Maintenance Manual
Description
– The server is switched off and
connected to the mains (standby
mode).
– The server has been switched on
but Power Cycle Delay settings
delay it from turning on for a
specified time.
I
After connecting the server to
the mains, it will take about 60
seconds until the server will
enter standby mode and can
be switched on.
– The server is switched off and not
connected to the mains.
– The server is switched on and
operating normally.
Description
A remote connection has been
established. Local VGA output has
been disabled during the remote
session.
An emergency flash of the iRMC
firmware is in progress.
"Updating or recovering the BIOS
Appendix A
461