Preliminary Steps; Removing A 3.5-Inch Hdd Module; Installing A 3.5-Inch Hdd Module; Concluding Steps - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) / solid state drives (SSD)
7.3.9.1

Preliminary steps

"Locating the defective server" on page 51
Ê
Ê If applicable, "Getting access to the component" on page
"Locating the defective component" on page 52
Ê
7.3.9.2

Removing a 3.5-inch HDD module

Ê Remove the HDD module, see section
on page 179.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.3.9.3

Installing a 3.5-inch HDD module

Ê If applicable, install the HDD in the installation frame, see section
HDDs or SSDs without installation frame" on page
Ê Install the HDD module, see section
page 182.
7.3.9.4

Concluding steps

Ê If applicable, "Reassembling" on page
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
RAID array rebuild" on page
182
117.
Upgrade and Maintenance Manual
"Removing a 3.5-inch HDD module"
164.
"Installing a 3.5-inch HDD module" on
67.
section"Performing a
55.
164.
"Handling
TX1330 M4