Replacing Expansion Cards; Preliminary Steps; Removing An Expansion Card - Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.3

Replacing expansion cards

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (only for installing slot brackets)
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.4.3.1

Preliminary steps

"Locating the defective server" on page 51
Ê
"Suspending BitLocker functionality" on page 97
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê Remove the system fan module, see section
module" on page 81
Ê If applicable, remove the SAS expander holder without disconnecting
cables, see section
Position the SAS expander holder on the HDD cages to get more space.
"Locating the defective component" on page 52
Ê
Ê Remove all external cables from the expansion card to be replaced.
9.4.3.2

Removing an expansion card

Ê Remove the expansion card, see section
page 285.
288
"Removing the SAS expander holder" on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
"Removing the system fan
"Removing expansion cards" on
256.
TX1330 M4