Connecting Ac Power To An Mx10000 - Juniper MX10008 Hardware Manual

SEE ALSO
General Safety Guidelines and Warnings | 313
Grounded Equipment Warning | 328
Removing and Installing MX10000 Power System Components | 191

Connecting AC Power to an MX10000

After you ground the chassis, connect the power supplies, and supply power to the chassis, the system
initiates the power-on sequence. This sequence can start incrementally with a single power supply, but it
is not recommended that you bring up an MX10000 system with at less than three power supplies.
Before you begin to connect power to the router, be sure you understand how to prevent ESD damage.
See "Prevention of Electrostatic Discharge Damage" on page
To connect AC power to an MX10000 chassis:
1. Connect the chassis to earth ground (see
CAUTION:
to ensure proper operation, an MX10000 must be adequately grounded before it is
connected to power.
For installations that require a separate grounding conductor to the chassis, use the
protective earthing terminal on the rear panel of the MX10000 to connect to the
earth ground.
An MX10000 gets additional grounding when you plug the power supply in the router
into a grounded AC power outlet by using the AC power cord appropriate for your
geographical location. See
2. Install power supplies in the router and apply power. See
Supply" on page 196
SEE ALSO
JNP10K-PWR-AC Power Supply | 61
How to Install a JNP10K-PWR-AC Power Supply | 196
Connecting an MX10000 to Earth Ground | 160
"Connecting an MX10000 to Earth Ground" on page
To meet safety and electromagnetic interference (EMI) requirements and
"MX10000 Power Cables Specifications" on page
or "How to Install a JNP10K-PWR-AC2 Power Supply" on page
343.
"How to Install a JNP10K-PWR-AC Power
163
160).
107.
208.