Connecting Dc Power To An Mx10000; Connecting The Mx10008 To External Devices - Juniper MX10008 Hardware Manual

Connecting DC Power to an MX10000

The overall process of bringing up a DC-powered chassis involves the proper cabling of the individual
power supplies, adding the power supplies to the chassis, and supplying power. The power-on sequence
can start incrementally with a single power supply, we recommended that you bring up an MX10000
system with at least three power supplies.
Each power supply input feed must be connected to a dedicated DC power source outlet.
Before you begin connecting power to the router, be sure you understand how to prevent electrostatic
discharge (ESD) damage. See
To connect DC power to a JNP10K-PWR-DC power supply, see
Supply" on page 220. To connect DC power to a JNP10K-PWR-DC2 power supply, see
JNP10K-PWR-DC2 Power Supply" on page
SEE ALSO
JNP10K-PWR-DC Power Supply | 65
JNP10K-PWR-DC2 Power Supply | 68
Prevention of Electrostatic Discharge Damage | 343
RELATED DOCUMENTATION
General Safety Guidelines and Warnings | 313
Grounded Equipment Warning | 328

Connecting the MX10008 to External Devices

IN THIS SECTION
Connecting an MX10008 to a Network for Out-of-Band Management | 165
Connecting an MX10008 Router to a Management Console | 166
"Prevention of Electrostatic Discharge Damage" on page
234.
343.
"How to Install a JNP10K-PWR-DC Power
"How to Install a
164