19. Verify that the INP1 and INP2 LEDs on the power supply faceplate are lit and are on steadily.
20. Press the power switch to the on (|) position.
SEE ALSO
How to Remove a JNP10K-PWR-AC Power Supply | 191
Connecting AC Power to an MX10000 | 163
Power Requirements for an MX10008 Router | 100
Field-Replaceable Units in an MX10008 | 38
JNP10K-PWR-AC Power Supply | 61
How to Remove a JNP10K-PWR-AC2 Power Supply
The JNP10K-PWR-AC2 power supply in an MX10008 or an MX10016 chassis is a hot-removable and
hot-insertable field-replaceable unit (FRU). You remove all power supplies from the rear of the chassis.
WARNING:
removing a working JNP10K-PWR-AC2 power supply from the chassis. These power
supplies can reach 158°F (70°C ).
CAUTION:
sufficient to power the router left in the chassis. See
MX10008 Router" on page
Before you remove an JNP10K-PWR-AC2 power supply from the chassis:
Ensure you understand how to prevent ESD damage. See
on page
343.
Ensure that you have the following parts and tools available to remove a JNP10K-PWR-AC2 power supply
from an MX10000 router:
Heat protective gloves able to withstand temperatures of 158°F (70°C)
Electrostatic discharge (ESD) grounding strap
Protect yourself from severe burns by wearing heat-protective gloves when
Before you remove a power supply, ensure that you have power supplies
100.
"Power Requirements for an
"Prevention of Electrostatic Discharge Damage"
204