Jnp10K-Pwr-Ac Power Supply Leds - Juniper MX10008 Hardware Manual

CAUTION:
attached an appropriate grounding lug to the grounding cable that you supply. Using a
grounding cable with an incorrectly attached lug can damage the router.
NOTE: DC power supplies are shipped only in the redundant configuration of MX10008 routers.
For details about different chassis configurations, see
on page 31 and MX10016 Components and Configurations.

JNP10K-PWR-AC Power Supply LEDs

An AC power supply has four LEDs on its faceplate: INP1, INP2, PWR OK, and FAULT. These LEDs display
information about the status of the power supply. See
Figure 33: LEDs on an JNP10K-PWR-AC Power Supply
1 FAULT
—
2 PWR OK
—
Table 16 on page 71 describes the LEDs on a JNP10K-PWR-AC power supply.
Before you begin installing the router, ensure that a licensed electrician has
1 2 3 4
"MX10008 Components and Configurations"
Figure 33 on page 70.
3 INP2–Source input 1
—
4 INP1–Source input 0
—
70