Removing And Installing Mx10000 Power System Components; How To Remove A Jnp10K-Pwr-Ac Power Supply - Juniper MX10008 Hardware Manual

Removing and Installing MX10000 Power System
Components
IN THIS SECTION

How to Remove a JNP10K-PWR-AC Power Supply | 191

How to Install a JNP10K-PWR-AC Power Supply | 196
How to Remove a JNP10K-PWR-AC2 Power Supply | 204
How to Install a JNP10K-PWR-AC2 Power Supply | 208
How to Remove a JNP10K-PWR-DC Power Supply | 215
How to Install a JNP10K-PWR-DC Power Supply | 220
How to Remove a JNP10K-PWR-DC2 Power Supply | 230
How to Install a JNP10K-PWR-DC2 Power Supply | 234
MX10008 and MX10016 routers support both AC and DC power supplies. Additionally, MX10000 routers
support high-voltage alternating current (HVAC) or high-voltage direct current (HVDC) power supplies.
To install and remove the power supplies in a MX10008 router or a MX10016 router, refer to the following
sections.
How to Remove a JNP10K-PWR-AC Power Supply
The JNP10K-PWR-AC power supply in an MX10008 router is a hot-removable and hot-insertable
field-replaceable unit (FRU). You remove all power supplies from the rear of the chassis.
CAUTION:
sufficient to power the router left in the chassis. See
MX10008 Router" on page
Before you remove an JNP10K-PWR-AC power supply from the chassis:
Before you remove a power supply, ensure that you have power supplies
100.
"Power Requirements for an
191