Mx10000 Power Cables Specifications; Jnp10K-Pwr-Ac Power Cable Specifications - Juniper MX10008 Hardware Manual

MX10000 Power Cables Specifications

IN THIS SECTION

JNP10K-PWR-AC Power Cable Specifications | 107

JNP10K-PWR-AC2 Power Cable Specifications | 110
JNP10K-PWR-AC2 Power Cable Specifications for 30-A Input | 113
Each AC power supply has two independent 16 A rated AC inlets on the faceplate. Most sites distribute
power through a main conduit that leads to frame-mounted power distribution panels, one of which can
be located at the top of the rack that houses the router. An AC power cord connects each power supply
to the power distribution panel.
Each detachable AC power cord is 8 feet (approximately 2.5 meters) long. The appliance coupler at the
female end of the cord inserts into the AC appliance inlet on the faceplate of the AC power supply. The
coupler type is C19 as described by the International Electrotechnical Commission (IEC) standard 60320.
The plug at the male end of the power cord fits into the power source outlet that is standard for your
geographical location.
JNP10K-PWR-AC see "JNP10K-PWR-AC Power Cable Specifications" on page 107
JNP10K-PWR-AC2 with 20-A input, see
JNP10K-PWR-AC2 with 30-A input, see
on page 113
JNP10K-PWR-AC Power Cable Specifications
Table 39 on page 108 lists the AC power cord specifications for MX10008 routers for various countries
and regions.
"JNP10K-PWR-AC2 Power Cable Specifications" on page 110
"JNP10K-PWR-AC2 Power Cable Specifications for 30-A Input"
107