Test Cut Dialog In Nc Code - Roland monoFab SRM-20 User Manual

Test Cut Dialog in NC Code

For a cutting data file written in NC code, test output is possible on the VPanel to check it for the presence of mistakes (bugs) .
""Cut Dialog"
(p . 17)
No. Display
File
Change
Coordinatesystem view
Cutting Speed
Quit Cutting
Close
1
2
Function
The files whose output you want to test are displayed here .
Select the coordinate system that is used to display the
coordinates in the VPanel's main window .
You can adjust the feed rate of the cutting tool .
""Adjusting the Feed Rate and Spindle
Speed During Cutting"
Setting unit : 10%
Setting range : 10% to 200%
Click this button during cutting to stop cutting .
Close this dialog .
5
3 6
4
No. Display
(p . 106)
110
Test output conditions
• When the current command set is
• When the selected file is "NC code."
Function
The code of the file whose output you want to test is displayed
here .
Click this button to generate test output one block at a time .
When you click this button, the next block is executed .
Click this button to pause the test output . When you click this
button while test output is paused, output begins again .
Click this button to execute output as indicated by the program .
Click this button to execute test output at the maximum cutting
tool feed rate . All operations other than the cutting tool feed
rate are executed according to the program .
NC Code Setting
"NC code."