Responding To Error Messages - Roland DWX-51D User Manual

Responding to Error Messages

This section describes the error messages that may appear on VPanel and how to take action to remedy the problem. If the
action described here does not correct the problem, if an error message not described here appears, contact your authorized
Roland DG Corporation dealer.
Error number
The % limit switch
is not found.
1000-****
(% may be "X," "Y,"
"Z," "A,"or "B.")
The % axis position
has been shifted.
1006-****
(% may be "X," "Y,"
"Z," "A,"or "B.")
The front cover is
1017-0000
open.
The milling bur
101C-0000 s e n s o r i s n o t
found.
T h e % m i l l i n g
b u r c a n n o t b e
101D-**** released.
(% may be "1 to
10")
60
4. Troubleshooting
Message Situation/error cause
The operation may be
inhibited by milling
waste or an obstruction.
The motor position may
have been lost.
The milling conditions
may be excessively strict.
The front cover was
opened during spindle
rotation.
(For safety, the machine
comes to an emergency
stop if the front cover is
opened while the spindle
is rotating.)
The operation may be
inhibited by milling
waste or an obstruction.
The returning of the
milling bur failed. The
inside of the collet or
the ATC magazine might
be dirty.
The collet and milling bur
are affixed together and
cannot be separated. The
inside of the collet might
be dirty.
Action
1. Turn off the power.
2. Remove any objects blocking operation of the
machine and any accumulated milling waste.
3. Turn on the power, and then restart operation.
1. Remove any objects blocking operation of the
machine and any accumulated milling waste.
2. Press and hold the operation button on the
built-in panel. This will clear the error.
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Review the CAM settings and the shape
specified in the CAD data.
To continue milling
Press the operation button on the built-in panel
to resume milling.
To stop milling
Press and hold the operation button on the
built-in panel.
Do not open the front cover while the spindle is
rotating. Doing so may affect the milling results.
1. Turn off the power.
2. Remove any objects blocking operation of the
machine and any accumulated milling waste.
3. Turn on the power, and then restart operation.
1. Press and hold the operation button on the
built-in panel. This will clear the error.
2. Clicking "Open collet" in VPanel will open the
collet. Remove the milling bur.
P. 9""Maintenance" Tab"

3. Clean the ATC magazine.
P. 34"Cleaning after Milling Finishes"

4. Retighten the collet.
P. 41"Retightening the Collet"

If the error occurs again even after you perform
the above operations, the collet may have
become deformed. Replace the collet with a
new one.