Setting The Connection Parameters; If You've Selected Rml-1 - Roland CAMM-3 PNC-3200 User Manual

6

Setting the Connection Parameters

Connection with a parallel cable is called a "parallel connection," and connection with a serial cable is called a "serial connection." Make
the appropriate settings on both the computer and the PNC-3200 to configure the equipment for the type of connection that has been
made. Normally, the setting on the computer should be made to match the setting on the PNC-3200. The steps below describe how to
set connection parameters on the PNC-3200. To make the settings on the computer, refer to the manual for the computer or the software
in use.

If You've Selected RML-1

1
Press the [MENU] key to make the following screen
appear on the display.
3
Press the [MENU] key to make the following screen
appear on the display.
5
Press the [ENTER] key.
7
Make the settings for stop bit, data bits, and parity
check, then press the [MENU] key once.
For serial connection
Make sure
that "< >" appears.
only
2
Press the [ ] key to move the blinking cursor (" ") to
"OTHERS," and then press the [ENTER] key.
4
Press the [ ] key to move the blinking cursor (" ") to
"I/O," then use the [ ] or [ ] keys to select "AUTO."
6
Press the [MENU] key once.
8
Make the settings for baud rate and handshake.
For serial connection
only
19