Test The Oscillate Axle - Genie S-80 Service Manual

February 2017
A-6
Perform Engine Maintenance –
Perkins Models
Engine specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
• Engine oil level – check
• Coolant level – check/add
• Oil, fuel and coolant systems- check for
leaks
• Fuel pre-filter- drain water
• Air filter discharge valve - clean
Required maintenance procedures and additional
engine information are available in the Perkins
404F Series Operation Manual.
Perkins 800 Series Operation and Maintenance
Manual
Genie part number
Perkins 404F Series Operation Manual
Genie part number
Part No. 1259369GT
Checklist A Procedures
A-7
Test the Oscillate Axle (if
equipped)
Genie specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
2 Drive the right steer tire up onto a 6 inch / 15
cm block or curb.
111332
Result: The three remaining tires should stay
in firm contact with the ground and the chassis
1251562
should remain level at all times.
3 Drive the left steer tire up onto a 6 inch / 15 cm
block or curb.
Result: The three remaining tires should stay
in firm contact with the ground and the chassis
should remain level at all times.
4 Drive both steer tires up onto a 6 inch / 15 cm
block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Note: If the chassis does not remain level during
test, Refer to Repair Procedure, How to Set Up the
Directional Valve Linkage.
S-80 • S-85 • S-80X
Service Manual
Tip-over hazard. Failure to
perform this procedure on a
firm, level surface will
compromise the stability of the
machine and could result in the
machine tipping over.
25