Table of Contents
Advertisement
9 - 14
ENGINE 2.0L DOHC
ENGINE 2.0L DOHC (Continued)
• Mark flex plate to torque converter position.
Remove torque converter bolts.
(27) Lower vehicle.
(28) Disconnect positive cable from battery and
PDC.
(29) Disconnect ground cable from left side trans-
axle mount bracket.
(30) Disconnect throttle and speed control cables.
(31) Disconnect coolant recovery container over-
flow hose.
(32) Disconnect heater hose at thermostat housing.
(33) Disconnect all ground straps attaching to
engine.
(34) Disconnect brake booster and vapor purge
vacuum hoses.
(35) Disconnect fuel line from fuel rail.
(36) Disconnect generator connectors.
(37) Remove
intake
ENGINE/MANIFOLDS/INTAKE
REMOVAL).
(38) Remove generator.
(39) Remove A/C suction line at compressor. Cap
suction port and line.
manifold
(Refer
to
MANIFOLD
(40) Remove A/C compressor.
(41) Raise vehicle enough to allow engine dolly
6135 and cradle 6710 with posts 6848 to be installed
under vehicle (Fig. 6).
(42) Loosen cradle engine mounts to allow move-
ment for positioning onto engine locating holes on the
engine bedplate, compressor and support bracket.
Install adapters 6909 to the two post at rear of
engine. Lower vehicle and position cradle mounts
until the engine is resting on posts. Tighten post
mounts to cradle frame. This will keep mounts from
moving when removing or installing engine/transmis-
sion assembly. Secure engine/transmission to dolly/
cradle with safety straps.
(43) Lower vehicle so weight of the engine and
transmission ONLY is on the cradle.
(44) Remove right and left side vertical engine
9
-
mount bolts.
-
(45) Slowly raise vehicle in short length spans.
Inspect at each interval for potential engine or trans-
axle contact to vehicle components. Move the cradle/
dolly fixture as necessary to allow for removal
clearance.
JR
Advertisement
Table of Contents
