Stacking by Device
ICX 7150 stack configuration overview
ICX 7150 stacking trunks
All ports on both ends of a trunk must be configured at the same speed. The lead port in a stacking trunk must be a valid-stack-
port. The default valid-stack-ports come up automatically as 10-Gbps ports (assuming they are licensed). Additional 10-Gbps
ports require a license.
NOTE
Two 10-Gbps stacking ports are standard on ICX 7150-48ZP devices.
Stacking trunks can be configured as part of the stack interactive-setup process. Trunks can also be added when a link is down or
on a production unit as described later in this section.
The following table lists ports that can be combined as stacking trunks. Refer to
on page 36 for more information on linear-topology trunks.
TABLE 20 ICX 7150 stacking trunk options
Model
ICX 7150-C12P
ICX 7150-24
ICX 7150-24P
ICX 7150-48
ICX 7150-48P
ICX 7150-48PF
ICX 7150-48ZP
Creating ICX 7150 stacking trunks while the link is down
Follow these steps to create a trunk while the link is down.
NOTE
Use the stack-port command while the link is down to remove stacking trunks and restore individual stacking ports.
1.
Enter global configuration mode.
ICX7150-24 Router(config)# configure terminal
2.
(Optional) Use the show stack command to check the stack topology and status.
ICX7150-24 Router(config)# show stack
T=36m46.7: alone: standalone, D: dynamic cfg, S: static
ID
Type
1
S ICX7150-24
2
S ICX7150-48P
standby
+---+
3/3| 2 |3/1==3/1| 1 |3/3
+---+
Will assign standby in 56 sec due to all ready
Standby u2 - protocols ready, can failover
Current stack management MAC is 00e0.5200.0100
The example shows a two-unit stack with both units in the Ready state. The units are connected by a trunk through stack
ports 1/3/1 and 2/3/1.
96
Valid-stack-ports
1/3/1, 1/3/2
1/3/1, 1/3/3
1/3/1, 1/3/3
1/2/1, 1/2/3
Role
Mac Address
active
00e0.5200.0100 128 local
standby 748e.f882.e418
active
+---+
+---+
Additional stacking ports
None
1/3/2, 1/3/4
1/3/2, 1/3/4
1/2/2, 1/2/4
Pri State
Comment
Ready
0 remote
Ready
Support for two-unit stack linear-topology trunks
Two-port trunks
Not supported
1/3/1-1/3/2, 1/3/3-1/3/4
1/3/1-1/3/2, 1/3/3-1/3/4
1/2/1-1/2/2, 1/2/3-1/2/4
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Linear-topology trunks
stack-trunk 1/3/1 to 1/3/2
stack-trunk 1/3/1 to 1/3/4
Not supported
stack-trunk 1/2/1 to 1/2/4
Part Number: 53-1005572-01