Creating A Two-Unit Icx 7850 Stack With A Linear-Topology Trunk Using Stack Interactive-Setup - Arris Ruckus ICX 7850 Series Configuration Manual

Warning: inconsistent stacking trunk port speed was found in:
stack-trunk 1/3/1 to 1/3/4 has
1/3/1 in speed 100Gbit
1/3/2 in speed 100Gbit
1/3/3 in speed 40Gb
Creating a two-unit ICX 7850 stack with a linear-topology trunk
using stack interactive-setup
Complete the following steps to use stack interactive-setup to create a two-unit ICX 7850 stack with a linear-topology trunk.
1. In global configuration mode on the unit that will server as the active controller, enter the stack enable command to
enable stacking.
ICX7850-32Q Router# configure terminal
ICX7850-32Q Router(config)# stack enable
Enable stacking. This unit actively participates in stacking
ICX7850-32Q Router(config)# end
2. On the active controller, enter the stack interactive-setup command. When prompted to select an option, select 2 if
the new unit is a clean unit to discover and convert new units to stack members. To keep the proposed configuration,
enter y when prompted.
NOTE
If you attempt to run stack interactive-setup immediately after enabling stacking, the following message may
be displayed: T=3m37.8: Some ports are in HighGig mode. Please try again in 30 seconds.
In the following example, all eight ports (1/3/1 to 1/3/8) are connected to the peer unit.
ICX7850-32Q Router# stack interactive-setup
You can abort stack interactive-setup at any stage by <ctrl-c>
0: quit
1: change stack unit IDs
2: discover and convert new units (no startup-config flash) to members
3: discover and convert existing/new standalone units to members
2&3 can also find new links and auto-trunk or convert chain(s) to ring.
Please type your selection: 2
Probing topology to find clean units...
T=5m14.1: Sending probes to ports: u1: 1/3/1 to 1/3/8,
Existing stack: ============================================================
+---+
3/1| 1 |3/5
+---+
Horizontal bars link to discovered units. Vertical bars link to stack units.
Chain #0: ==================================================================
#1: icx7850-48fs-port-management d4c1.9e18.8dd9
1/3/1
||
||
2/1
+---+
|#1 |
+---+
Discovered 1 chain/ring
Chain #0: Do you want to select this chain? (enter 'y' or 'n'): y
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
different speed 100Gbit/40Gbit :
Stacking by Device
ICX 7850 stack configuration overview
155