Naming A Stack Unit - Arris Ruckus ICX 7850 Series Configuration Manual

Stack Management

Naming a stack unit

Stack units must each have a unique identification number. Every stack member, including any standalone units, retains its stack
unit number unless that number is already being used in the stack, or until you manually renumber the unit using stack
interactive-setup. For more information about how to renumber stack IDs using stack interactive-setup, refer to
unit IDs with stack interactive-setup

Naming a stack unit

You can assign names to stack units to help identify them. Stack unit names can be up to 63 characters long. A stack unit name
must start with an alpha character and must not contain spaces.
Perform these steps to assign a name to one or more stack members.
1. Enter global configuration mode.
device# configure terminal
2. Enter the stack unit command followed by the number of the stack unit you want to name.
device(config)# stack unit 1
The device enters stack unit configuration mode.
3. Enter the unit-name command followed by the name that you want to represent the unit in configuration output.
device(config-unit-1)# unit-name operations
The example assigns the name operations to stack unit 1.
4. (Optional) Repeat steps 3 and 4. You can repeat this step as many times as needed.
device(config-unit-1)# stack unit 2
device(config-unit-2)# unit-name engineering
The example enters stack unit configuration mode for unit 2 and assigns the name engineering to the unit.
5. When you are finished naming units, enter the write memory command in Privileged Exec mode to save the
configuration.
device(config-unit-2)# end
device# write memory
194
on page 75.
Changing stack
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01