Icx 7650 Stack Configuration Overview - Arris Ruckus ICX 7850 Series Configuration Manual

Creating stacking trunks on live stacks
Use the multi-stack trunk or multi-stack port command to add or remove a stacking trunk on a live ICX 7450 stack. The
following example creates two stacking trunks.
device# configure terminal
device(config)# stack unit 1
device(config-unit-1)# multi-stack-trunk 1/2/1 to 1/2/2 and 2/2/1 to 2/2/2
device(config-unit-1)# end
device(config)# end
device#
NOTE
You can use the multi-stack-port command to create individual ports on a live stack. Available ports on slot 2 are 1/2/1
and 1/2/3.

ICX 7650 stack configuration overview

The following table provides an overview of ICX 7650 stacking capabilities.
TABLE 23 ICX 7650 stacking capabilities
Stacking capability
Topologies supported
Maximum stack size
Maximum stacking distance
Stacking ports
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
ICX 7650
Ring and linear
12
10 Kilometers
ICX 7650 devices support 40-Gbps and 100-
Gbps stacking.
Stacking by Device
ICX 7650 stack configuration overview
Additional information
NOTE
ICX 7650 devices can operate in a
stack only when the rear module
(Module 3) is in Stacking Mode.
Stacking is not available when the
rear module is configured in
Uplink Mode. Refer to
rear-module options
for more information.
Refer to ICX 7650 stacking topologies
119 for sample linear and ring topologies.
Stacking only. Can serve as Control Bridge
stack in 802.1br (Campus Fabric)
configurations. Any combination of ICX 7650
devices may be stacked.
Refer to FastIron stacking distances and
optics by device on page 50 for more
information.
Module 3 supports 4 X 40-Gbps stacking or 2
X 100-Gbps stacking (the default).
Stacking port speeds can be changed to 40-
Gbps with the rear-module stack-40G
command. Refer to Changing ICX 7650
stacking speed on page 124 for instructions.
Refer to ICX 7650 stacking ports
for module and port locations.
ICX 7650
on page 123
on page
on page 119
117