Icx 7850 Stacking Topologies - Arris Ruckus ICX 7850 Series Configuration Manual

TABLE 25 ICX 7850 stacking capability (continued)
Stacking capability
Valid-stack-port sets
Reconfigurable ports
Trunks
Linear-topology trunks
Hitless switchover and hitless failover
License requirements
Configuration options
Access methods
Stacking commands

ICX 7850 stacking topologies

The following figures show available ICX 7850 stacking ports on the front panel. On ICX 7850-32Q devices, valid-stack-ports are
1/3/1 and 1/3/5 and available stacking ports are 1/3/1 through 1/3/8. On ICX 7850-48F and ICX 7850-48FS devices, stacking ports
are in the same location on the front panel; however, the module is number 2. Valid-stack-ports on ICX 7850-48F and ICX
7850-48FS are 1/2/1 and 1/2/5 and available stacking ports are 1/2/1 through 1/2/8.
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
ICX 7850
ICX 7850-32Q: (x/3/1, x/3/5, 4)
ICX 7850-48FS/48F: (x/2/1, x/2/5, 4)
NOTE
The third number in the set is the
maximum number of ports in a
stacking trunk. The number "1"
indicates a single stack-port only.
Use the stack-port and stack-trunk
commands to reconfigure ports.
The following maximum stacking trunk
configurations are supported:
ICX 7850-32Q: stack-trunk 1/3/1 to 1/3/4 or
stack-trunk 1/3/5 to 1/3/8
ICX 7850-48FS/48F: stack-trunk 1/2/1 to 1/2/4
or 1/2/5 to 1/2/8
The following maximum linear-topology
trunks are supported:
ICX 7850-32Q: stack-trunk x/3/1 to x/3/8
ICX 7850-48FS/48F: stack-trunk x/2/1 to x/2/8
Supported
No license required for stack-port
configuration. No license required for
Premium features.
Manual and automatic, including stack
interactive-setup and stack zero-touch
provisioning
TFTP, SCP
All stacking CLI is supported on ICX 7850
devices unless otherwise stated on the
command reference page.
Stacking by Device
ICX 7850 stack configuration overview
Additional information
Refer to the definition of valid-stack-port set
in Stacking terminology on page 19 and
stack-port sets on page 23 for more
information.
Refer to ICX 7850 stacking topologies
151 for port locations.
Stacking port speeds are auto-detect and
cannot be configured.
See also "Linear-topology trunks" in this table.
Refer to Support for two-unit stack linear-
topology trunks on page 36 for more
information.
Refer to Hitless stacking on page 171.
For more information on ICX 7850 license
options, refer to the Ruckus FastIron Software
Licensing Guide.
Refer to Stack construction methods
56.
Software images, boot images, and signatures
can be downloaded to a stack using TFTP and
SCP applications. Refer to the Ruckus FastIron
Software Upgrade Guide for more information.
Valid-
on page
on page
151