Icx 7450 Stacking Topologies - Arris Ruckus ICX 7850 Series Configuration Manual

TABLE 22 ICX 7450 stacking capability (continued)
Stacking capability
License requirements
Configuration options
Access methods
Stacking commands

ICX 7450 stacking topologies

Up to 12 ICX 7450 units of any kind can be connected in a linear or ring topology. Valid-stack-ports are located on the rear panel
as shown in the following figures. The valid-stack-port numbers are 1/3/1 and 1/4/1 (unit/slot/port); that is, they are the single
port located in modules 3 and 4 of the ICX 7450 as shown.
The following figure shows the valid-stack-ports for the ICX 7450. These ports may also be used as data ports.
FIGURE 19 ICX 7450 1 X 40-Gbps valid-stack-ports
The following figure shows the 4X10GF module and port numbers.
NOTE
Changing stacking ports from 1/3/1 and 1/4/1 to any port on Module 2 (1/2/1 through 1/2/4) requires you to enter the
write memory and the reload commands.
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
ICX 7450
No license required for stack-port
configuration
Manual and automatic, including stack
interactive-setup and stack zero-touch
provisioning
TFTP, SCP
These commands are not available on ICX
7450 devices, except as noted:
multi-stack-port, except when a 4X10GF
module is present in slot 2
multi-stack-trunk, except when a 4X10GF
module is present in slot 2
stack-trunk, except when a 4X10GF module
is present in slot 2
Stacking by Device
ICX 7450 stack configuration overview
Additional information
Premium feature requires trust-based license.
Refer to the Ruckus FastIron Software Licensing
Guide for information.
Refer to Stack construction methods
56.
Software images, boot images, and signatures
can be downloaded to a stack using TFTP and
SCP. Refer to the Ruckus FastIron Software
Upgrade Guide for more information.
on page
109