Displaying Information About Stack Neighbors - Arris Ruckus ICX 7850 Series Configuration Manual

Unit# System uptime
1 18 minute(s) 33 second(s)
2 17 minute(s) 30 second(s)
3 18 minute(s) 46 second(s)
TABLE 34 Field descriptions for the show stack command
Field
alone: Standalone
S: static configuration
D: dynamic configuration
ID
Type
Role
MAC address
Pri (Priority)
State
Comments
Role history
NOTE
The active controller removes the dynamic configuration of a unit when the unit leaves the stack. However, if there is a
static trunk configuration associated with the unit, the active controller cannot remove the dynamic configuration. In
this case, you must remove the static trunk and use the no stack unit stack-unit command to manually remove the
configuration.
TABLE 35 Field descriptions for the show stack detail command
Field
Stack Port Status
Neighbors
Unit #
Stack-port 1
Stack-port 2

Displaying information about stack neighbors

The show stack neighbors command displays information about stack member neighbors.
ICX7750-26Q Router# show stack neighbors
U# Stack-port1
1 (1/2/1-1/2/2) to U2 (2/2/4-2/2/5)
2 (2/2/1) to U3 (3/2/4)
3 (3/2/1-3/2/3) to U1 (1/2/4-1/2/6)
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
Description
This device is operating as a standalone device.
The configuration for this unit is static (has been saved with a write
memory command).
The configuration for this unit is dynamic and may be overwritten by a
new stack unit. To change to a static configuration, enter the write
memory command.
The stack identification number for this unit
The model of this unit
The role of this unit within the stack
The MAC address of this unit
The priority assigned to this unit
The operational state of this unit
Additional information about this unit (optional)
Tracks up to six role changes per stack unit. The initial state is always
displayed. Overflow is indicated by ellipses (...). Standby to member
role changes are not displayed. Role history also does not display the
transition after bootup of a non-active controller unit from member to
standby.
Description
Indicates stacking port status for each stack unit
Identifies stack neighbors (by unit ID) for each stack unit
The stack identification number for this unit
Indicates the port state (up or down) and identifies the port by
number (stack-ID/slot/port)
Indicates the port state (up or down) and identifies the port by
number (stack-ID/slot/port)
Stack-port2
(1/2/4-1/2/6) to U3 (3/2/1-3/2/3)
(2/2/4-2/2/5) to U1 (1/2/1-1/2/2)
(3/2/4) to U2 (2/2/1)
Stack Management
Displaying stack information
227