Stacking By Device; Icx 7150 Stack Configuration Overview - Arris Ruckus ICX 7850 Series Configuration Manual

Stacking by Device

•

ICX 7150 stack configuration overview..................................................................................................................... 89

• ICX 7250 stack configuration overview................................................................................................................... 102
• ICX 7450 stack configuration overview................................................................................................................... 107
• ICX 7650 stack configuration overview................................................................................................................... 117
• ICX 7750 stack configuration overview................................................................................................................... 136
• ICX 7850 stack configuration overview................................................................................................................... 150
ICX 7150 stack configuration overview
The following table provides an overview of ICX 7150 stacking capabilities.
TABLE 19 ICX 7150 stacking capabilities
Stacking capability
Topologies supported
Maximum stack size
Maximum stacking distance
Stacking ports
Valid-stack-port sets
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
ICX 7150
Ring and linear
12 units
10 Kilometers
Four 1-Gbps / 10-Gbps ports on fixed module
on front panel that are available for stacking
when configured for 10-Gbps operation
NOTE
ICX 7150-C12P devices have two 1-
Gbps / 10-Gbps ports that are
available for stacking.
On most models, (x/3/1, x/3/3, 2)
On ICX 7150-C12P devices, (x/3/1, x/3/2, 1)
On ICX 7150-48ZP devices, (x/2/1, x/2/3, 2)
NOTE
The third number in the set is the
maximum number of ports in a
stacking trunk. One indicates
stack-port only.
Additional information
Refer to ICX 7150 stacking topologies
92.
Stacking and SPX configurations. Any
combination of eligible ICX 7150 devices may
be stacked. When a stand-alone ICX 7150 is
configured as a PE unit attached to a control
bridge in an 802.1br SPX configuration,
scaling is increased. Refer to the Ruckus
FastIron Campus Fabric Configuration Guide for
more information.
Refer to FastIron stacking distances and
optics by device on page 50 for more
information.
On most ICX 7150 models, module 3 on the
front panel contains four ports that can be
used as stacking or uplink ports.
On ICX 7150-C12P devices, module 3 on the
front panel contains two ports that can be
used as stacking or uplink ports.
On ICX 7150-48ZP devices, module 2 on the
front panel contains four ports that can be
used as stacking or uplink ports.
Refer to ICX 7150 stacking topologies
92 for module and port locations.
Refer to the definition of valid-stack-port set
in Stacking terminology on page 19 and
stack-port sets on page 23 for more
information.
Refer to ICX 7150 stacking topologies
92 for port locations.
on page
on page
Valid-
on page
89