Displaying Software Version Information - Arris Ruckus ICX 7850 Series Configuration Manual

TABLE 29 Field descriptions for the show running-config command
Field
ver
stack unit #
module #
priority
stack-port
stack-trunk
stack enable
stack mac
aaa authentication web-server default local
aaa authentication login default local
enable aaa console
(no) telnet server
hitless-failover enable/disabled
sz registrar
sz active-list ip address, ip address
interface management 1
ip address
How the show running-config command displays configured stacking ports
FastIron release 08.0.90 always display stacking ports regardless of whether stack enable is configured. FastIron releases prior
to 08.0.90 may not display stacking ports when stack enable is not configured. In all releases, stacking ports can be used as data
ports if stack enable is not configured.

Displaying software version information

The show version command shows the software version that the stack is running. The last line of the output shows the bootup
ID and role for the unit. Output resembles the following example.
ICX7750-26Q Router# show version
Copyright (c) Ruckus Networks, Inc. All rights reserved.
UNIT 2: compiled on Jan 22 2019 at 10:59:04 labeled as SWR08090
(30097250 bytes) from Primary SWR08090.bin
SW: Version 08.0.90devT203
Compressed Primary Boot Code size = 1835520, Version:10.1.15T205 (swz10115b3)
Compiled on Mon Dec 17 11:02:22 2018
UNIT 1: compiled on Jan 22 2019 at 10:59:04 labeled as SWR08090
(30097250 bytes) from Primary SWR08090.bin
SW: Version 08.0.90devT203
Compressed Primary Boot Code size = 1835520, Version:10.1.15T205 (swz10115b3)
UNIT 3: compiled on Jan 22 2019 at 10:59:04 labeled as SWR08090
(30097250 bytes) from Primary SWR08090.bin
SW: Version 08.0.90devT203
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
Description
Software version the stack is running
The stack identification number for this unit
Identifies the configuration for each module installed in the stack unit
Indicates the priority assigned to the stack unit
Lists stacking ports configured on the stack unit
Indicates the trunk configuration
Indicates whether the stack is enabled
Specifies the mac address for the stack
Indicates the authentication method to access the device through web
management is to use local username and password
Indicates the authentication method to access the device through cli
via telnet/ssh is to use local username and password
Indicates authentication, authorization, and accounting (AAA) is
enabled on the console
Indicates whether telnet server is enabled or not on this device
Indicates whether hitless failover is enabled
Present by default and indicates that the device can initiate auto-
discovery of up to two configured SmartZone management IP
addresses by querying a pre-configured URL. Refer to SmartZone
administrator guides for more information.
Displays the list of IP addresses used by the ICX device to connect to
SmartZone. Refer to SmartZone administrator guides for more
information.
Indicates FastIron management port
Indicates the IP address that identifies the stack
Stack Management
Displaying stack information
221