About This Guide; Supported Hardware; What's New In This Document - Arris Ruckus ICX 7850 Series Configuration Manual

About This Guide

•

Supported hardware................................................................................................................................................... 13

•

What's new in this document.....................................................................................................................................13

Supported hardware
This guide supports the following Ruckus products:
• Ruckus ICX 7850 Series
• Ruckus ICX 7750 Series
• Ruckus ICX 7650 Series
• Ruckus ICX 7450 Series
• Ruckus ICX 7250 Series
• Ruckus ICX 7150 Series
For information about what models and modules these devices support, see the hardware installation guide for the specific
product family.
What's new in this document
The following tables provide descriptions of new information added to this guide for FastIron software release 08.0.90.
TABLE 2 Summary of enhancements in FastIron release 08.0.90
Feature
ICX 7850 stacking
Configuration and behavior changes,
overview
Interactive-setup for stacking replaces
stack secure-setup
Zero-touch provisioning for stacking
Elimination of required default-ports
configuration
Two-unit linear-topology trunks
Ruckus FastIron Stacking Configuration Guide, 08.0.90
Part Number: 53-1005572-01
Description
Stacks of up to 12 ICX 7850 units are supported.
Numerous changes in stacking configuration are
introduced in this release. The key changes are
itemized in the remainder of this table. The
section referenced in the next column provides
an overview of the major changes.
The stack interactive-setup command is
introduced to streamline and assist in stack
configuration. The stack secure-setup
command is deprecated.
The stack zero-touch-enable command is
introduced to allow automatic stack
configuration.
The default-ports command is deprecated
beginning with this release. Configuring stacking
ports is simplified.
From this release, two-unit linear-topology
trunks are supported on all ICX stackable
models. The linear-topology trunk doubles the
bandwidth of the stacking ports between two
units and provides the same redundancy as a
two-unit ring through trunk load balancing.
Location
Refer to ICX 7850 stack configuration overview
on page 150 for more information.
Refer to Changes to Stacking in FastIron
Release 08.0.90 on page 23 for more
information.
Refer to Stack interactive-setup
for more information.
Refer to Stack zero-touch provisioning
page 33 for more information.
Refer to No more stack default-ports
configuration on page 24 for more
information.
Refer to Support for two-unit stack linear-
topology trunks on page 36 and to the
topology section for each ICX model for more
information.
on page 31
on
13