Rear Roller Brushes (Optional) - Toro Greensmaster 3120 Service Manual

Rear Roller Brushes (Optional)

g230193
1. Rear roller brush for cutting units with or without a belt
driven groomer
DPA Cutting Units: Service and Repairs
There are two different types of rear roller brush kits for Greensmaster 3120
cutting units. The earlier type of kit is designed to fit on cutting units with or
without a belt driven groomer. A later type of kit is designed to fit on cutting
units with or without a universal groomer. Please take a moment to determine
which type of rear roller brush kit is installed on the cutting unit as the service
information is different for each rear roller brush type.
Note: The Installation Instructions for the rear roller brush kit has detailed
information regarding assembly and adjustment. Use the Installation Instructions
along with this Service Manual when servicing the rear roller brush.
Drive components for the rear roller brush are located on the left side of the
cutting unit (opposite from the hydraulic cutting unit motor).
Figure 129
2. Rear roller brush for cutting units with or without a
universal groomer
Page 7–34 Greensmaster 3120
17230SL Rev C