Table of Contents
Advertisement
Installing the Bedbar (continued)
Greensmaster 3120
17230SL Rev C
7. Install the bedbar pivot bolt assemblies. Make sure the washers are not
caught on the threads of the pivot bolts. Tighten each bedbar pivot bolt from
22 to 27 N∙m (190 to 240 in-lb).
Do not over tighten the lock nuts as this can distort the side plates
and affect reel bearing alignment. When the lock nut is correctly
tightened, the inside washers may be loose.
8. Tighten both lock nuts (item
have any end play and can still can be rotated.
9. Tighten the lock nut (item
until the adjuster spring is fully compressed, then loosen the lock nut 1/2 turn.
10. Adjust the bedknife to reel contact; refer to the Cutting Unit Operator's
Manual.
IMPORTANT
10
in
Figure
110) until outside washers do not
13
in
Figure
110) on each bedbar adjuster assembly
Page 7–17
DPA Cutting Units: Service and Repairs
Advertisement
Chapters
Table of Contents
Troubleshooting
