Toro Greensmaster 3120 Service Manual page 157

Installing the Reel Motors
Greensmaster 3120
17230SL Rev C
Note: Inspect threads and sealing surfaces of the hydraulic fittings and the
hydraulic hoses prior to installation. Replace any damaged or worn fittings
or hoses.
1. Lubricate and fit new O-rings onto the reel motor fittings. Install the fittings
making sure that the fitting location and orientation is as noted during
removal. Tighten fittings as specified; refer to
(SAE Straight Thread O-Ring Fittings) (page
2. Coat the reel motor shaft splines with No. 2 multipurpose lithium base
grease. Lubricate the O−ring on the motor flange with clean fluid.
3. Rotate the motor clockwise so the motor flanges clear the flange head
screws in the cutting unit side plates. Align the reel motor shaft splines with
the cutting reel insert splines. Slide the motor shaft into the reel insert.
4. Rotate the motor counterclockwise until the motor flanges encircle the cap
screws in the side plates. While holding the motor, tighten the two (2) flange
head screws securing the reel motor to the cutting unit; refer to
When installing the hydraulic hoses, make sure that hydraulic hoses
are straight (not twisted) before tightening the hoses to the motor
fittings.
5. Remove the plugs and the caps from the hydraulic hoses and fittings.
Using the labels placed during removal, connect the hydraulic hoses to the
reel motor fittings. Tighten the connections as specified; refer to
Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
6. Charge the hydraulic system; refer to
4–79).
IMPORTANT
Charging the Hydraulic System (page
Page 4–111
Installing the Hydraulic Fittings
4–10).
Figure
Installing
4–8).
Hydraulic System: Service and Repairs
68.