The Grooming Brushes (Optional) - Toro Greensmaster 3120 Service Manual

The Grooming Brushes (Optional)

g229598
1. Spiral brush
2. Spiral brush shaft
3. J-bolt (2 each)
Belt Driven Groomer (Optional): Service and Repairs
4. Lock nut (2 each)
5. O-ring
6. Grooming brush
The optional grooming brush attaches to the groomer in place of the groomer
reel. The grooming brush is removed and installed from the groomer in the same
manner as the groomer reel; refer to
The grooming brush elements or shafts can be serviced separately.
To remove the spiral grooming brush from the shaft, remove the lock nut and
J-bolt from both ends of the brush assembly and slide the brush from the shaft.
When assembling the spiral brush to the shaft, make sure that the J-bolts are
installed with the threaded portion on the outside of the brush and tighten the
lock nuts from 2.3 to 2.8 N∙m (20 to 25 in-lb).
Figure 148
The Groomer Reel (page
Page 8–20
7. Grooming brush shaft
8. Roll pin (2 each)
8–16).
Greensmaster 3120
17230SL Rev C