Table of Contents
Advertisement
Removing the Drive Plate
Belt Driven Groomer (Optional): Service and Repairs
Refer to
Figure 137
for this procedure.
1.
Park the machine on a clean and level surface, lower the cutting units
completely to the ground, stop the engine, engage the parking brake and
remove the key from the ignition switch.
2.
Remove the cutting unit from the machine and place cutting unit on a flat
work surface.
3.
If equipped, remove rear roller brush from cutting unit; refer to
Rear Roller Brush (with or without a belt driven groomer) (page
4.
Remove the groomer drive cover and drive belt.
5. Loosen pinch bolts that secure the front roller shaft to the groomer arms.
g229452
1.
Pinch bolt
2.
Groomer reel
6. Remove the lock nut and spring washer that secure the LH groomer arm
to the drive plate assembly.
Note: To speed cutting unit setup after installing the groomer reel, do not
change the height adjustment bolt or the groomer adjuster setting.
7. Remove the lock nut, special washer and plow bolt that secure the LH
groomer arm assembly to the cutting unit side plate.
8. Remove the LH groomer arm and the front roller from the cutting unit.
Figure 138
3.
Lock nut
4.
Spring washer
Page 8–8
Servicing the
7–35).
5.
Groomer arm – LH
Greensmaster 3120
17230SL Rev C
Advertisement
Chapters
Table of Contents
Troubleshooting
